How To Level Ground For Pavers. Slide the carpenter's level along the string all the way around the rectangle. Level the exposed ground beneath the sunken pavers.
Use your measuring tape to adjust string as needed to show a slope of 3 inches over a length of 12 feet. Place a carpenter's level on the ground where you dug, and check the instrument to see whether or not the spot is level. Take the sand mold to a base level.
For Pavers To Drain, Ground Should Be Level But With A Slope Of 1 Inch To Every 4 Feet Of Length, To Facilitate Drainage.
If we want to add 4″ of crushed gravel, the stakes should be pounded at 9″ away from the strings. Attach a string level to the strings to determine the high point. Use your measuring tape to adjust string as needed to show a slope of 3 inches over a length of 12 feet.
Dig 6 Inches Into The Ground Along The Area Where The Pavers Will Rest.
Set the core upon a leveled surface, if necessary, and fill it ¾ full with damp sand. Fill the hose with water. Leveling sand or crushed stones to get a level ground can work in this situation.
If The Location Is Not Level, Then Remove The Carpenter's Level And Move Soil To Create A More Level Base.
Place a carpenter's level on the ground where you dug, and check the instrument to see whether or not the spot is level. Spray it with water from a hose until it reaches the right consistency, then smooth it out using a rake. Step 4 rake the area to further level the ground.
The Bubble Will Be Slightly Off.
If using paint, spray it around the perimeter to create an outline. Check that the slope of the string is even with your carpenter's level. Verify that the string's slope is also at the level of your carpenter.
Place A Carpenter's Level On The Ground Where You Dug, And Check The Instrument To See Whether Or Not The Spot Is Level.
Leveling is an indispensable part of the job when installing pavers on. Remember that all height references are measured from, and then down to, your baseline string. Use a rotavator to churn up the soil.