How To Cut Stair Stringers With A Circular Saw

How To Cut Stair Stringers With A Circular Saw. This will allow you to make a full 12 cut in one pass. Nail one 2×6 to each 2×12 stringer with staggered 10d commons approximately 6 inches o.c.

Stair Stringer Installation Extreme HowTo Blog
Stair Stringer Installation Extreme HowTo Blog from

I am … press j to jump to the feed. A circular saw is the cutting tool of choice for trimming out a stringer. The important thing to remember is to use a vertical up and down cutting action so you can get a nice clean 90 degree cut for the tread to sit against.

When Ordering Stringers, Allow About 14 Inches Of Stringer Length For Each Step.

Using a 10 or smaller saw that doesn't slide means you'll have to make two cuts on each side of the tread and is very difficult to achieve a quality cut. I have a cheap (entry level) battery operated ryobi circular saw. Can you cut stair treads with a circular saw?

Trim The Top And Bottom Of The Stair Stringer.

Take proper precautions before using the circular saw. Once one stringer is cut, use it as a template for the remaining ones (to save you time and reduce errors). When cutting a stair stringer, you must cut the marks that you just made using a circular saw, ensuring that you don’t go beyond the lines, and finish the cuts using a jigsaw or handsaw.

See also  How To Card Counter

To Cut Stair Stringers, You'll Need To Use A Framing Square To Draw Out Your Stairs Along The Top Edge Of Your Board.

Notching smaller stock doesn’t leave enough wood to safely carry the loads of a stair. “it’s much simpler for a. This means that no matter how deep your circular saw will cut, you’re still going to have to make four cuts at each cutout

Do Not Cut Beyond The Cut Lines, Because This Can Weaken Your Structure.

Take proper precautions before using the circular saw. Use your first stair stringer as a template to trace your remaining stringers. Nail one 2×6 to each 2×12 stringer with staggered 10d commons approximately 6 inches o.c.

Once You’ve Located Where The Stairs Will Attach To The Deck Framing According To.

The important thing to remember is to use a vertical up and down cutting action […] Once you've finished cutting out the stairs, trim the bottom and top of the stringer to size. Use this one as a stringer template for all of your other stringers so they match exactly.

Author:

Leave a Reply

Your email address will not be published.